News & Alerts

What Happened?

A campus employee working in an electronics shop was repairing a power supply unit. The cooling fan had not been working properly, causing the unit to overheat. The employee replaced the defective cooling fan and then reached into the open top of the power supply unit to check the airflow from the replacement fan. The employee either made contact with a charged capacitor or was close enough (within 1/4") to allow electricity to arc to his hand causing an electric shock that entered his left hand and exited through his right hand.

What Happened?

A UC Berkeley researcher was preparing a sample for microscopy. After he had cleaned the sample with isopropanol, he poured the extra isopropanol into a container for unwanted chemicals labeled “isopropanol.” There was an immediate chemical reaction that caused the plastic container to rupture and spray the mixture around the area. He was later surprised to learn that the container actually held concentrated nitric acid in the form of spent copper etchant.

What Happened?

A university employee was changing ballasts above a drop ceiling in a department reception area. The employee received an electrical shock from a 277volt circuit and was knocked off a step stool that she had placed on top of the reception desk. She fell from a height of 46.5 inches, but received only minor injuries and returned to work the following day.

In April 2003, the Non-Ionizing Radiation Safety Committee (NIRSC) informed the laser research community that a serious laser eye injury had occurred on the UC Berkeley campus. The campus Laboratory Safety Officer (LSO) performed an investigation of the incident. The following information and lessons learned are based on the LSO’s investigation of the incident.

What Happened?

Someone was using the vice pictured below to hold an item in the process of a normal workday. In the process of performing a task, the vice toppled off the surface onto the person's foot causing a serious injury. The person was not wearing steel-toed boots.

What Happened?

A can of epoxy hardener was included in a salvage cart (see photo) and spilled at some point in the process of moving the salvage cart. An employee came in contact with the spilled material and was instructed to immediately wash with soap and water. EH&S then cleaned up the spill (see photos).

Lessons Learned

Please remind your staff of proper disposal methods for hazardous materials.

Don't lose your thumb! Paper cutters such as the one here are not safe or legal. Cal/OSHA has cited campus departments for allowing unguarded paper cutters in the workplace in prior years.

Lessons Learned

Please be sure all paper cutters in your department have a guard like the one seen here.